Enter an option [Tang/Curvatre/Radius/Multiply/Fairing/Inflect/Extend/eXit]:
Tang - Sets tangent vectors at endpoints
Start tangent? [Yes/No]:
Specify tangent:
End tangent? [Yes/No]:
Specify tangent:
Curvatre - Sets the curvature values at the end points
Curvature in start point? [Yes/No]:
Specify curvature:
Curvature in endpoint? [Yes/No]:
Specify curvature:
Radius - Sets the value of the radius of curvature
Start Radius? [Yes/No]:
Specify centre of curvature (radius):
End Radius? [Yes/No]:
Specify centre of curvature (radius):
Multiply - Sets the multiplying factor (0,1,2)
Specify new subdiv mode<1>:
Fairing - Sets the curve improvement option
Enter fairing option (0 - off, 1 -on, 2 - arranging, 3 - correct acute angles) <0>:
Inflect - Sets the option for constructing an inflection section
Inflection form: fixed tangents = 0, smooth site = 1, super smooth = 2 <0>:
Extend - Enables the option to consider polyline end segments as tangent vectors.
4Exit - Exit.