Enter an option [Tang/Curvatre/Fairing/eXit]:
Tang - Sets tangent vectors at endpoints.
Start tangent? [Yes/No]:
Specify tangent:
End tangent? [Yes/No]:
Specify tangent:
Curvatre - Sets the curvature values at the end points.
Curvature in start point? [Yes/No]:
Specify curvature:
Curvature in endpoint? [Yes/No]:
Specify curvature:
Fairing - Sets the curve improvement option.
Enter fairing option (0 - off, 1 -on, 2 - arranging, 3 - correct acute angles) <0>:
Extend - Enables the option to consider polyline end segments as tangent vectors.
4Exit - Exit.